So i used some 99% isopropyl alcohol on a couple buttons on the deck and now my screen has weird streaks. I’m devastated. Will it be ok? It’s only viewable at certain angles but this has been the device i’ve taken best care of.

Update: The smudge is 99% gone but the weird X going across the whole screen remains. I’m only a little disappointed but I’ve been tinkering with electronics my entire life and I’ve never seen this before so I’m more fascinated than anything. View from my normal angle is undisturbed.

  • noride@lemm.ee
    18·
    6 days ago

    How long ago did you get iso in there? If it was really recent, there’s a chance it may evaporate and be good as new. If it’s been a while, take solace in knowing it probably won’t get worse, at least.

      • noride@lemm.ee
        111·
        6 days ago

        I would expect that at 70% or maybe even 90%, but 99% isopropyl should absolutely not leave a residue behind.

        • SpikesOtherDog@ani.socialEnglish
          4·
          6 days ago

          I used it for cleaning flux after soldering and it would sometimes leave a chalky white residue. It could have been the PCB reacting or other impurities. Anyway, the boss would sometimes complain about it, but they was what we had.

        • Gristle@lemmy.worldOPEnglish
          3·
          6 days ago

          it leaves residue on the shell. or it has in the past. but that typically comes off with use. Not that the inside is going to get any use haha

    • Gristle@lemmy.worldOPEnglish
      5·
      6 days ago

      Maybe an hour before that pic. it’s hard to see from my normal viewing angle so I’m bummed but it’s better than a brick. I have it off and hopefully drying but I’ll check back in on it in a day or two.

      • Norah (pup/it/she)@lemmy.blahaj.zoneEnglish
        3·
        6 days ago

        If it’s 99% isopropyl then it’s probably fine to leave it on now, as it has really low conductivity. The warmth from being on will also help evaporate it faster.